Deckote 500 (Car Deck Coating)


CHEMISTIK DECKOTE 500 is a one component acrylic rubber based, seamless floor finish. It can be applied on a variety of surfaces to provide a good aesthetic appearance to the floor and walls besides being smooth & glossy, it is dust proof, hard wearing and resistant to mild acids and alkalis. It facilitates easy maintenance of floors and walls and also extends their service life.


As a protective coat for concrete floors where light traffic exists and where dustfree, hygienic conditions are needed. It can be used very effectively in light industrial factories, operation theatres in hospitals, electronic factories and warehouses, pharmaceutical industries, dairies, prefabricated homes, containers, Car parking areas, garages, auto showrooms, Concrete Stadiums, etc.


Once the surface is prepared as per the instructions, the surface should be primed with primer coat of Chemistik AC 10 (Pure Acrylic Primer)
Stir the contents thoroughly before use. Allow primer to dry for about 2 – 3 hours and then commence applying the first coat of Chemistik Deckote 500 followed by second and subsequent coats to be applied within 6 – 8 hours interval between each coat. Intercoating interval should not exceed more than 8 – 10 hours.


Avoid inhalation of solvent vapours and avoid direct contact with skin and eyes. Provide proper ventilation when working with solvent borne coatings in confined spaces or stagnant air. Provide respiratory skin and eyes protection. Don’t smoke in the vicinity and away from open flames, lights etc.


Store in a cool dry place, away from direct sunlight. and from direct heat or naked flames.


25 Kgs.

  • It has excellent resistance to dirt, dust and other environmental pollutants.
  • Excellent resistance to oil, grease, petrol and certain chemical spillage.
  • It also has excellent resistance to some solvents.
  • Excellent abrasion resistance.
  • Very easy to clean, maintain and repair.
  • Easy to mix and apply, seamless coating by brush/mop/roller.
  • Good adhesion and flexibility.
  • Available in 10 Shades.
  • Saves money on maintenance and extends service life of floors.

New concrete surfaces should be cured for 28 days prior to coating. Old / Existing surfaces should be clean, firm and dry. All laitance curing membranes / coatings should be removed. The surface should be free from dust, loose dirt, oil, grease etc. and levelled. All pot holes, uneven surfaces, cracks, crevices should be repaired with Chemistik Rapid Repair Mortar. Very oily surfaces to be chemically cleaned with Florklin and then rinsed thoroughly and allowed to dry completely before applying primer coat.


Clean hands, tools etc. with Mineral Turpentine. The use of barrier creams is also recommended.

Deckote 500
Colour      : Available in 10 shades
Finish      : Smooth-Glossy / Antiskid
Drying Time @ 30°C Surface Dry      : 2 to 3 hours
Hard Dry      : 8 to 12 hours
Recommended Coats      : Two – Three
Dry Film Thickness      : 70 – 80 microns per coat
Scratch Hardness      : Excellent
Cold Resistance      : Sub 0°C
Heat Resistance      : 120°C – 140°C
Coverage      : 70 – 80 Sq.Ft. / Kg. / Coat
Flash Point      : Above 30°C